品牌：UD优道

产品编号：UD-247/1.5G

企业标准：Q/YK 058-2012

仅供4S店使用

产品特点：

1、在摩擦表面上生成金属陶瓷层，恢复或者优化零部件之间的配合精度；

2、能够恢复活塞环的几何密封性；提高并均衡各气缸的压力；

3、修复各摩擦部件的磨损并防止其继续磨损；

4、减少发动机的噪音和振动吗、降低燃油消耗、提高发动机功率、降低尾气中CO和HC的含量；

5、提升机油压力，延长发动机使用寿命；可与各种机油相溶。

使用方法：

1、预热发动机，到正常温度，然后关闭发动机；

2、打开发动机机油口盖，将优道缸压修复剂从机油口挤入，然后盖好机油口盖；

3、启动发动机，怠速5分钟；

4、正常行驶。当累计行驶50小时（或者1500公里），处理完成。

5、若需测试缸压变化，请怠速运转30分钟，运行500公里后测试效果更佳。

Product features:

1. Generate metal ceramic layer on the friction surface to restore or optimize the coordination precision between parts;

2. Can restore the geometric sealing of piston ring; Increase and balance the pressure of each cylinder;

3. Repair and prevent the wear and tear of all friction parts;

4. Reduce the noise and vibration of the engine, reduce fuel consumption, increase engine power, and reduce the content of CO and HC in tail gas;

5. Increase the oil pressure and extend the service life of the engine; It can dissolve with various oil.

Usage:

1. Preheat the engine to normal temperature and then close the engine;

2. Open the oil cap of the engine, and squeeze the pressure restorer of the cylinder into the oil port of the engine, then cover the oil cap;

3. Start the engine and idle for 5 minutes;

4. Drive normally. When traveling for a total of 50 hours (or 1,500 kilometers), the handling is complete.

5. If the cylinder pressure change needs to be tested, please idle for 30 minutes, and the test effect will be better after running 500 kilometers.