1, This product USES the new technology synthesis resin, safe environmental protection;
2 ,Protect the bottom metal from water to avoid rust;
3, Plug the joint gap of the parts, fasten the screws to avoid falling off during driving;
4, Remove the noise from the bottom of the car to prevent the impact of sand and stone;
5,Improve the comfort of the vehicle and extend the service life of the vehicle.
1. To spray parts of the car will thoroughly clean, if have should be razed and rust sanding, to clean, no water, no oil, no wax mark will need not spraying parts (the exhaust, engine, water tank, spring, air conditioner condenser, etc) closely covered.
2. Fully moved this article about 2 minutes, open the irrigation cover, remove the seal and insert the factory special spray gun, connection0.6-0.8 Mpa compressed air. In the distance spraying the surface of about 25 cm place, spray evenly back and forth.
3. To prevent flow mark and baggy, suggested in three spraying. In the first time after the completion of the spraying of hole, crack in car use, to blow be bored with child fill seal flat; For a time after dry before spraying (not less than 15 minutes) and then spraying. 1.5 mm thickness above sound insulation effect is obvious.
4. This product did not work to solid available before gasoline to clean
Avoiding Any Eye Contact ,if contact, please immediately with plenty of clean flowing water and seek medical advice immediately;
If swallowed, don't spits, seek medical advice immediately and show this container or label the dress items.